Sharing the Fulltime Lifestyle
Living fulltime in an RV.
785 topics in this forum
-
- 21 replies
- 3.8k views
-
- 31 replies
- 6.4k views
-
- 9 replies
- 1.8k views
-
- 7 replies
- 2.8k views
-
- 12 replies
- 2.3k views
-
- 41 replies
- 8.4k views
-
- 1 reply
- 1.2k views
-
- 15 replies
- 2.2k views
-
- 5 replies
- 1.7k views
-
- 19 replies
- 3.5k views
-
- 15 replies
- 2.9k views
-
- 10 replies
- 2.2k views
-
- 32 replies
- 4.4k views
-
- 10 replies
- 1.7k views
-
- 15 replies
- 2.1k views
-
- 4 replies
- 1.8k views
-
- 18 replies
- 2k views
-
- 5 replies
- 2.2k views
-
- 27 replies
- 4.9k views
-
- 12 replies
- 1.8k views
-
- 7 replies
- 1.7k views
-
- 20 replies
- 3.8k views
-
- 42 replies
- 9.2k views
-
- 13 replies
- 1.8k views
-
- 19 replies
- 2.3k views
-
Topics
-
-
Posts
-
Moving onto my next project which is to build a ramp system for loading a 2-Door Jeep onto the deck of my Volvo. Pretty much starting off with a clean deck with the TSLB installed. Who can share ideas, plans, material list. I can weld the materials together and then bolt to my frame rails and to existing parts of my truck. Buy or build Jeep ramps? How long? Will cut off my storage box in order to make more room for the Jeep 13' length. Planning to have Jeep 50" away from King Pin or as needed. Have seen Jack M. ramp system really nice and can not do so I my truck, most likely will store ramps next to the Jeep. Let the ideas begin and pictures of your Jeep systems are most welcomed. Will need a welding magnet to mount my camera on; where to purchase? -
I am alittle high hence looking at the leveling value to take away about one inch if you smart folks think that will be OK? The TSLB was alot of work to install, just put in the last 8 bolts 5/8"x 2" today. Have not tied into my air system to be able to air up the hitch bags. About to start a new post on ramps to get a Jeep up on my deck.
-
Dennis- I went through this exercise last year and found that using only math, caused me to mock my hitch up too high. One I loaded my trailer and put the air at the correct pressure for my application, I found that REAL world results were much more accurate. My hitch works fine now. Part of my work was to extend the frame rails as well as installing a TSLB and new wiring. The wiring on my truck was in some places, burned, so I deleted it all and installed a junction box with a terminal strip, which will improve and troubleshooting efforts in the future, esp since I know the guy that will likely DO the troubleshooting. I also replaced my Smart Brake with a DirecLink. Nice improvement. -
Hi We are looking for good covered storage close to Charlotte Airport for the period october 2024 to april 2025. 35'6" long Class A, 8' wide, 12' high Anyone have good experience? Thanks Frank -
If you are in the Dallas area and need emergency health care for a dog or cat, there is an exceptionally good and well equipped facility called MedVet. They do not do routine care only emergencies and veterinarian referrals. The hospital is on a par with the best of the human hospitals and they have at least 1 veterinarian and 2 licensed vet techs on duty 24/7 with other veterinarian specialists on call as needed. As you may surmise, they are expensive but the care is pretty much the same as you would get at any major hospital.
-
