rpsinc Posted October 13, 2021 Report Share Posted October 13, 2021 WLP- that turned out very nice!! Quote Marcel Link to comment Share on other sites More sharing options...
Chad Heiser Posted October 15, 2021 Report Share Posted October 15, 2021 I’m jealous. Very nice work. Quote 2000 Kenworth T2000 w/ Cummins N14 and autoshift 2017 DRV Mobile Suite 40KSSB4 with factory mods, dealer mods and personal mods - now in the RV graveyard 2022 DRV Full House MX450 with customized floor plan 2018 Polaris RZR Turbo S (fits in the garage) 2016 Smart Car (fits in the garage or gets flat towed behind the DRV when the RZR is in the garage)My First Solar Install ThreadMy Second Solar Install Thread & Photos and Documents Related to the buildMy MX450's solar, battery and inverter system - my biggest system yet! chadheiser.com West Coast HDT Rally Website Link to comment Share on other sites More sharing options...
jenandjon Posted October 16, 2021 Report Share Posted October 16, 2021 That is real nice. Good work! Quote Farmer, Trucker, Equipment operator, Mechanic Quando omni flunkus moritati-When all else fails, play dead I'm a man, but I can change, if I have to, I guess. Link to comment Share on other sites More sharing options...
wlp Posted October 16, 2021 Author Report Share Posted October 16, 2021 Thank you lessons learned Always make sure you have your sheet metal lined up when you’re using the 3M tape. Once it touches it stuck. Secondly, make sure you remove the plastic covering film from your panels before you use 3M tape. Quote Link to comment Share on other sites More sharing options...
noteven Posted October 16, 2021 Report Share Posted October 16, 2021 3 minutes ago, wlp said: Thank you lessons learned Always make sure you have your sheet metal lined up when you’re using the 3M tape. Once it touches it stuck. Secondly, make sure you remove the plastic covering film from your panels before you use 3M tape. Doh! Quote "Are we there yet?" asked no motorcycle rider, ever. Link to comment Share on other sites More sharing options...
Sculptor Posted November 4, 2021 Report Share Posted November 4, 2021 On 10/5/2021 at 10:10 PM, wlp said: I am laying out the frame of the drom so I can still get at my bed's access pannels The square holes in the corners allow room for fueling? Or did you modify those since the photo? My (ahem) design allows for my hand or a fuel nozzle, but not both, and I think I have more room. Quote Kevin and June 2013 Volvo VNL 730 D13 Eco-Torque @ 425 Ratio 2.47 2014 DRV 36TKSB3 Link to comment Share on other sites More sharing options...
wlp Posted November 4, 2021 Author Report Share Posted November 4, 2021 I can access the fuel caps from the side of the truck with no issue. That was a priority before I started the build. The top triangle gaps are for access to the fuel return /breather lines that go into the fuel tanks as well as the APU fuel line to the right fuel tank. When I put the drom box on I used a 3/16 cut out that cover up the access points. The welder, plasma and tool chest is on the right side of the drom while the consumable/ durable storage products are on held on a shelving unit to the left side of the drom box. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.