GlennWest

New fridge in. And I am tired.

My wife has followed me for years. Some of the smaller parks was problem but mst not. But we actually have 3 vehicles. My wife health going own and she don't drive much anymore. We have quit traveling due to this. It is quite boring following a vehicle always.

What you stated may be correct though. The entire time we have been in our Teton the toilet burbs when tank full or near full. Had to say which since sensors don't work. A new roof was installed by previous owner and dealership just cut all vents off at surface. Our black tank vent was below the roof and venting in the attic space. I lengthened it to get up above. We got an oder until I did that.

Had no smell with the previous toilet.

Will know in a few days. emptied tank this morning. As tank filled smell got worse. Right now no smell. Seal I removed was just a dougnut. This one I replaced it with has a bottom flange with a rubber seal inside for toilet.

It is a new thedford aqua magic. Think I have it fixed now.

How much did it raise the toilet up?

When I replaced our toilet we used the new seal that came with it. It was a donut shape sorta rubber like. It lets smell come by it. What your suggestion. I am thinking getting a wax ring.

We have had cell data service everywhere we have been for years now. Now we don't go boondocking.

We have been streaming for years now. Don't intend to ever go back to dish.

Man at scrapyard actually was going to pay me for it. I was so glad to find a way to dispose of it I declined.

I got the wood off today. Stored away. Fridge gone to scrapyard now. Wife and I taking today realized the only other item in our home that hasn't been replaced is the dryer. Well fireplace also but it don't work either just not replaced yet. So 20 year mark it.

I got the short boards off where the water dispenser was. Work on long section tomorrow. It don't give up easy.

Thank you. I posted this to show that wood I am going to have to trash. sad

You all will have to fix this link. Never works for me.

[IMG]https://i.imgur.com/630rtTOl.jpg[/IMG]

My replacement is near same size. Is a little taller but I have a piece of trim I can remove if needed. Sides should be fine

I pulled trim off and it glued good. No a screw in it. Would love to save but don't think possible

Just a note. Teton had glued beautiful wood to front of our fridge. It seems a shame to throw away but it is on good. But i was surprised at how heavy the doors were due to this wood.

Found some on Amazon.

I put a fan in my inverter area. Gets rather hot in there. Cut hole in door and mounted fan. Want a thermostat for it. Most all 12v units are for heat. mine needs to work for cooling. Fan pulls 4 watts at 12v.

Got doors off and it pulled out from wall. It is only 24" deep without doors. So it will go thru door.

Will pull out from wall and remove doors before pulling window. Measure. Hope you are right but looks doubtful to me.

Ubolt broke. Seen this on one side with no load. Didn't go that far back but being hook up I can see this happening.

depth of mine is 33". 36" wide. Won't go thru our door/25 3/4".