Saddle Posted July 25, 2015 Report Share Posted July 25, 2015 We're the proud new owners of this HDT, and we just added to it a Newmar Cypress 37ft. New chapter in our lives for sure. Truck runs well, but I am trying to find out how to read the settings in the ECM. It has a Detroit Series 60 11.1L engine. Is there a way that I can read and/or change any of the Data in the ECM? With a laptop and software, and the proper cable? Thanks, Greg Link to comment Share on other sites More sharing options...
VegasFlyer Posted July 25, 2015 Report Share Posted July 25, 2015 Welcome to the forum and the new chapter in your life. I do not have any experience with the Series 60, but have seen a couple different interface modules for connecting to the ECM. John Southern Nevada 2008 Volvo 780, D13, I-Shift 2017 Keystone Fuzion 420 Toyhauler 2017 Can-Am Maverick X3-RS Link to comment Share on other sites More sharing options...
Mark and Dale Bruss Posted July 25, 2015 Report Share Posted July 25, 2015 This is a job for a shop with the equipment. The adapter and mostly the software is too expensive. Also the parameters are very cryptic for an amateur. The minimum will be and hour. Get a printout and recommendations for settins, like no idle shutoff, remove max speed. I like to set the minimum cruise to 20 mph. Please click for Emails instead of PM Mark & DaleJoey - 2016 Bounder 33C Tige - 2006 40' Travel SupremeSparky III - 2021 Mustang Mach-e, off the the Road since 2019 Useful HDT Truck, Trailer, and Full-timing Info atwww.dmbruss.com Link to comment Share on other sites More sharing options...
Saddle Posted July 26, 2015 Author Report Share Posted July 26, 2015 Thanks for your answers. So assuming the hour charge, is that normally to read it, change it and be done? Of course, get the printout. Link to comment Share on other sites More sharing options...
Mark and Dale Bruss Posted July 26, 2015 Report Share Posted July 26, 2015 Yes Please click for Emails instead of PM Mark & DaleJoey - 2016 Bounder 33C Tige - 2006 40' Travel SupremeSparky III - 2021 Mustang Mach-e, off the the Road since 2019 Useful HDT Truck, Trailer, and Full-timing Info atwww.dmbruss.com Link to comment Share on other sites More sharing options...
SunJuniper Posted July 27, 2015 Report Share Posted July 27, 2015 We're the proud new owners of this HDT, and we just added to it a Newmar Cypress 37ft. New chapter in our lives for sure. Truck runs well, but I am trying to find out how to read the settings in the ECM. It has a Detroit Series 60 11.1L engine. Is there a way that I can read and/or change any of the Data in the ECM? With a laptop and software, and the proper cable? Thanks, Greg if your out west , i can do it for next to nothing... i got the software/hardware combo. Detroits are my specialty anyways since i also own one. Series 60 12.7L (the 11.1L bigger brother) Fulltimer Class of 2007 1998 Volvo VNL64T610 Detroit Series 60 12.7 470HP/1650TQ Eaton 18spd 228"WB Tandem2006 40' ToyHauler 3 slides and a 14' Toybox Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.