GlennWest

Just use a resin?

Sorry, didn't make this clear. Rear cap area. Teton used a 3 piece ladder due to rear awning. Center section comes out. I removed the lower secion. I left the top section. Good hand hold to come off of straight ladder.

After I removed my ladder I am left with 4 screw holes 4 sets. For now just dicored it. I would like a more permament repair. Any suggestions.

We got ther 3 jumbo filters from them. Good water flow. "South of the Border" system

Just a note here. We can make it as cold in here now as we desire. DW actually had it down to 68 in here with a heat index outside of 105. Don't know why. But I went outside. lol

Had to run it at an angle due to the dometic ac still on roof. I almost ran drain line to the ground but already had algae in the other drain to shop vac out so made this one short.This cassette does pump the water out so may be non issuse. The brown junk on side of Teton is tape glue where I attempted to hold cover in place. Bad idea. Got ot remove that. Ended up putting screw in sides. Going to relocate that batwing attenna before solar. Move to middle. Haven't used it on years.

I did. Bookmarked it too. I had went there earlier and didn't get the results. Link went right to it

Don't have a dump valve. Need to plumb it one of these days

hugh. I went thier and put in 453 wiper blades and got no results. Thanks.

It is 6" to the top. 1/2" plywood top which I intend to change. Need to find a sheetmetal shop to make me a lid that covers top and sides and use weatherstripping for seal. I don't own a metal brake.Will get some more pics but storming today. Have about a 1.5" clearance on top so it could have been a little shorter but should be no problem with Solar panels being this high later. Have not removed rear Dometic yet. Wait till cooler weather. That was mean up there. Also going to remove the skylight also. We don't care for it. Heat sink. Also soft spot where I had leak. Small area.

Just went their and no listing for mine.

I went there and no listing that fits. Mine are also both the same length and their shows two different lengths.

Thanks. Sure beats finding dealerships

I am having an issuse finding replacement blades for my 453 unit. The parts chain stores list one but it doesn't fit.

I raised my camper up but didn't get clearance under it. Have in past and it wouldn't come out. When it came out, hitch slamped upward and even cause springs to come out. That don't sound right.

Saw nothing to cause leak. Dicored all edges and heavy on corners. Sealed top with eternabond tape. Will have to cut off now if I need to get in there. Don't see need anytime soon. Heald 400psi nitrogen.

I was having no luck with that a couple days ago. Was using duckduckgo browser. Changed to edge and it worked.

I just wondering why the leveling valve don't bleed off as hitch going up. The truck will.

Well, hard rain today. Yes, Glenn has a leak. Bummer. Between box and roof. Corner. Thought I got it all covered good. Reckon not. Used Eternabond tape. Seeping not pouring. Butyl tape gasket on top seeping also. So soon as weather breaks, back on roof.

Thanks. Have not meet anyone else with the ET.