Rick & Alana

Good job

Vern I hope I’m not too late. If you’re still in the Nashville area. 
When my engine went down. A friend of mine had me take it to 

B and B Truck Repair in Murfreesboro, Tn.  They are an excellent shop. 

For sale  SOLD

JACKALOPEE wiring  conversion unit

its been on the truck I sold for 11 years. Never had a problem with it. It was mounted inside under the bunk. 
 

$85.00 you pick up or pay freight. 
 

located north of Kansas City,MO about an hour. 
 

see my add for ET Hitch on this thread also. 

I have a used ET Hitch for sale. 
it’s listed in the for sale section or private message me. 

ET HITCH FOR SALE    SOLD

This is Henry’s standard 4 bag hitch with the Binkley top plate.  It was purchased in the summer of 2010. Henry and Tommy converted it to the newer style cross bars at the HDT Rally in 2013. It was mounted on a 2000 VNL770, have used grease on the hitch since new. (yes I’m old school) The hitch has approximately 67,000 miles on it. Sold my HDT, new owner did not need.
Located north of Kansas City,Mo about 45 minutes. 
$2300.00 you pick up or pay freight. 

Send me a private message to discuss. Or request pictures. 
 

I just poked around in it using my iPad. Worked just fine! 

Thanks Mark

I still use it and recommend it to people on FaceBook. 

Usually access it on my iPad. 

Thanks for your work on it. 

If you want a shop to look at it. I'd recommend

Northland Truck Service

7731 East Front Street

Kansas City, Mo 

816-483-7790

talk to Danny

they are not far from this dealer. 

They inspected mine 10 Years ago. And I've known them for probably 30 years. Great independent truck shop.  You can tell them Rick Jennings sent you. 

Good luck! 

20 hours ago, wtgeodog said:

Sitting at S&B in Midland, TX until we leave for Hutch.

I bought an ET Jr. for delivery at the rally.

I hope to be able to draft enough help to put it on my Toter.

Here is the truck when looking for help at the rally. 

Open your hood

grab a fist full of tools

grab a greasy red rag

look under your hood

before you can look back up, most likely there will be multiple on lookers  willing to help  

however some will only want to offer advise, but you'll have plenty to help

that is unless it's at meal time, happy hour  or bedtime

Call Brown I think it will pay to shop. 

Steve and I both have boxes made by Brown Industries. They are located in Lawerance Kansas.

And I think I can speak for both of us that we are very satisfied with the end product. 

http://www.bcvi.com/

It sounds like he lost his prime before he changed the fuel filters. Does the D13 have check valves in the fuel delivery system to keep this from happening that may of gone bad? Or maybe a lift pump? 

And I'm assuming you shouldn't start it on either like we used to do the older  Detriit and Cummins engines when they lost prime. 

Keep in mind tractor engine horse power vs PTO output HP. 3 point implements are rated at PTO out hp. Now if your just blading that's not a problem.

We bought a Masey Ferguson 39 hp 4 wheel drive, 60 in bucket, box blade and brush hog last fall. Haven't used it much. I like it so far.

Jeff C made the comment when I ask a year or so ago to buy the one that you have the most confidence in the dealer.

I paid a little more but followed my gut on dealer preference.

Las Vegas, NV back at the Clark County Shooting Complex on north Decatur

We found a part number on his old part. Googled it and found the part. If I remember it came out of Washington state. He will chime in here soon I'm sure.

In Vegas during the winter we stay at the Clark County Shooting Complex. However it's just a large parking lot basically. No pool or amenities and NOT lick of shade.

We are north of Kansas City about 45 minutes up I 35. Setting up on the farm we have purchased.

Did you have to drive through that Colorado Snow Storm?

 

Rod

No we came back on I-40, wind was the issue the whole trip. Then ran into the fires in Kansas. Hutchinson was very smokey with some lite ash falling.

Sitting at the fairgrounds in Hutchinson, Ks. Home of the National HDT Rally. Just here for the night.

Arrived in Congress, AZ at the North Ranch this evening for the winter. Stop by and say hello.

Sorry I missed you guys

Rick, glad you made it through.

 

We are down at our normal place in Mission, TX getting ready for our Mission Trips across the border to finish a huge project started last January.

Take care of the knee

Glad y'all got there safe, Rick. You've been in our thoughts the past few days.

Thanks, reports are that Flagstaff got 9 inches of snow before it moved on east. Glad we got threw when we did.

Las Vegas, NV at the Clark County Shooting Complex, will be here for a few months at least

We have landed at the farm in Platte City, Mo. Which is near Kansas City.