Jump to content

Shirley M

Validated Members
  • Posts

    7
  • Joined

  • Last visited

Posts posted by Shirley M

  1. 4 hours ago, Chad Heiser said:

    Every TV lift in an RV I have ever seen has been 12 volt powered.  This means the circuit will be a fuse in the 12 volt power panel, not a circuit breaker in the 120 volt power panel.  Check the fuses, then check the wiring at the switch and the motor for the lift.

    Thank you for the suggestion.I will try it out. There are a lot more 12 volt fuses than I am used to dealing with.

  2. 13 hours ago, Kirk W said:

    According to her profile, she has a 2013 Sanibel 3400 fifth wheel from Prime Time RV, a division of Forest River. 

    Am I correct that this is a powered raise and lower device? Does it seem to make any attempt to move or make any sound when you try to lower it? I would think that it probably shares a circuit breaker with the TV, so does the TV work? Also, did you open and then close each of the circuit breakers, or just look at them? It is very difficult to tell if  a circuit breaker has tripped with most of them as the handle moves very little but it must be moved to the fully open position in order reset it if it has tripped. 

     

    Yes, I tried turning off each circuit breaker.  There is no sound or attempt to move when I try to lower it.  The TV works.

    Thank you for your reins.

  3. Standard receivers are being outdated and will no longer work.  I have an HD receiver  with a dish on a portable stand which I understand is not allowed.

    I part time in fiver which is never moved.  I too have been with DTV for over 20 years and plan to give it up for streaming. Since AT&T took over, service has gone to the pits, cost is ridiculous, and they are losing channels.

×
×
  • Create New...