Jump to content

LCI (Lippert) Entry Step Issue


Recommended Posts

An issue with the LCI (Lippert) Entry Steps made itself known this week. When retracting - the steps close completely, however the step motor stays engaged and simply "clunks" against the gear for approximately 10 "clunks" ... then shuts itself off. It is as though the system doesn't realize the steps have fully retracted. I crawled under there and don't see any sort of "mechanical" switches that appear to stop the steps. I've read the documentation that I have - and didn't see anything about adjustment. Anybody have any ideas what I should be looking for?

Link to comment
Share on other sites

I have been through 2 Lippert entry steps in less than 3 years. As far as I am concerned they are junk. I was advised by a technician at Lazy Days that problems with the motors for Lippert steps is very common. Sorry, I don't have a solution for your problem, but I finally switched to another brand of steps.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

This topic is now closed to further replies.
RVers Online University


Our program provides accurate individual wheel weights for your RV, toad, and tow vehicle, and will help you trim the pounds if you need to.

RV Cable Grip

All the water you need...No matter where you go

Country Thunder Iowa

Nomad Internet

Rv Share

Dish For My RV.

RV Air.

Find out more or sign up for Escapees RV'ers Bootcamp.

Advertise your product or service here.

The Rvers- Now Streaming

RVTravel.com Logo

  • Create New...