General RV Information
General discussion forum for RVers.
3,720 topics in this forum
-
- 15 replies
- 551 views
-
- 4 replies
- 478 views
-
- 29 replies
- 9.8k views
-
- 2 replies
- 365 views
-
- 9 replies
- 441 views
-
- 3 replies
- 374 views
-
- 2 replies
- 388 views
-
- 2 replies
- 313 views
-
- 1 reply
- 208 views
-
- 16 replies
- 957 views
-
- 4 replies
- 351 views
-
- 10 replies
- 528 views
-
- 0 replies
- 467 views
-
- 15 replies
- 848 views
-
- 61 replies
- 16.2k views
-
- 3 replies
- 369 views
-
- 1 reply
- 239 views
-
- 7 replies
- 546 views
-
- 7 replies
- 423 views
-
- 15 replies
- 603 views
-
- 15 replies
- 661 views
-
- 24 replies
- 1.1k views
-
- 7 replies
- 348 views
-
- 10 replies
- 570 views
-
- 27 replies
- 6.4k views
-
Topics
-
-
Posts
-
By texastraveler1 · Posted
We are looking at options for class c rv's. I have researched the pros and cons for gas vs diesel but I cannot find anything that compares engine noise. We had a 2006 gas class A many years ago and the engine noise was horrible. I know dp's are much quieter because the engine is in the back, but what about a class C? Both types of engines are in the front, so, is one quiter than the other? -
-
Glad she's back. Happy trails. -
Maybe that's in hopes of keep us itinerants out of California? Linda -
The big black box used to live on the Gold Truck where the front axle used to be. With the White truck having both I needed to find a new place for it. Before I left for the HDT Rally I found it would fit in the box with the Motorcycle, so I strapped it down for the trip. Pondering all winter on what to do with it. I mounted a small vice to it and maybe I'd already mounted the Montezuma Tool box to it before leaving Iowa too. Anyway earlier this month I thought of mounting it to the inside of the box at "Workbench height.". The box has a couple rails built into the walls for "E" Track and I looked at multiple hardware locations before buying some carriage bolts. First ones too small, but would fit into the groove easily. Went to 1/2 inch and all I had to do was grind off two opposite sides and it would turn into it like a "T" and the 1/2 inch shoulder fit the slot almost perfectly . Cut up a chunk of old implement tire I had and made a 4inch long bumper to hold the bolt in place and provide some vibration dampening (Maybe). So far it feels very secure in it's position, but going down the road on it's first road trip will b the test. The last photo with the Craftsman tool box and a scrap of Angle Iron is an idea to mount the Angle under the box for more support. At one point I thought of putting a wooden support, but not sure that would be necessary and would rob me of some storage under the box. What have I done wrong or maybe didn't think of? Rod
-
