Jump to content

lockmup68

Validated Members
  • Posts

    971
  • Joined

  • Last visited

About lockmup68

  • Birthday 05/20/1969

Optional Fields

  • Lifetime Member
    Lifetime Member

Contact Methods

  • Website URL
    http://www.bronco.com
  • ICQ
    0

Profile Information

  • Gender
    Male
  • Location
    MIddle TN

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

lockmup68's Achievements

  1. The business is for sale, yes, but still in business.
  2. Thanks for the reminder. I completely forgot about them.
  3. They are still open. Just super busy and can't look at it until May/June. They are doing a lot of flexarmor roofs now.
  4. Need to get underbelly/insulation redone. Had a leak and pulled all the original off and chucked. So looking for chloroplast/insulation install on 40' Teton. Currently in FL, headed back to TN soon. Need done asap. Appreciate the recommendations.
  5. Where in Montana, we've been there since June, just left. West of Missoula.
  6. If you are replacing several of them, do it in Montana or any other state with no sales tax. Will save you a bit.
  7. think of it as a 45' class a pulling a 25' trailer. You will be shorter than most or the same as an F350s and 5vers.
  8. International 9200i, Cummins ISX, Meritor Freedomline Reported a few times over the last five years, intermittent trans goes into "SM" or system malfunction mode, ABS lights on and off, sometimes dies in gear and cannot restart because it is not in neutral, etc. So after a ton of testing, replacing some sensors, and finally, just getting International on the line and waiting for days and days. Finally, there was a TSB on the transmission and the wiring harness. There is an overlay transmission wiring harness, ~$500, that seems to have fixed the issue. Since it was an overlay, vs. a plug and play harness, had to remove each individual pin in the various connectors and replace with the new wires, was a total pain, and took 19 hours of shop time to get it installed. However, issue is finally resolved. NOTE: if the ABS light is on, the transmission will not auto shift, defaults into manual mode. HTH someone with the freedom line. Shannon
  9. it's a good book and online, gives the site numbers and the lengths of each site they recommend. Very helpful.
  10. I had to put a new head on my QD8k as the controller board is soldered to the head. It was about $2500, but the Kubota diesel just keeps cranking. I have about 300 more hours on it now and happy with the repair. New QD8k is about $10k. Also, I have it mounted between the frame rails behind the rear axle on the truck. Been like that for 10 years. I've owned the truck for 5.
  11. lockmup68

    TSLB Damage

    Definitely need a rebuild on that. My story link above.
  12. Money well spent. Once you tow with one, you will never go back. This is my favorite video:
  13. y'all have fun. Will be attending college graduation that week. Hopefully, can get one off the payroll soon.
  14. Full, no bueno.....we are persona non grata apparently.
  15. lockmup68

    Bronco Sport

    Bronco Sport should not have a bronco badge. It's like an escape replacement. Actual bronco is pretty capable out of the box.
×
×
  • Create New...