I've been following this discussion closely because I have a older comfort ride hitch 308. It doesn't have the straps on it so I think it's the older design it was on my truck when I bought it 2 years ago and the gentleman I bought it from had it for 3 years but the hitch could of been used then I just don't know. So I thought I should inspect the hitch to check I lifted it up and sure enough the weld at both ends are cracked. The problem is I can weld up and add some bracing but it has a plastic bushing inside and I don't know how to keep it from melting. any one got a ideal? How do you guys think this should be braced. The one thing I don't like is the pivots for the head are mounted into the sides and that is 1/8 steel I want to make new pins that are longer and weld on blocks on the outside to support that extra length also drill the pins to keep them from walking out I found them coming out already and as thin as it is It wouldn't take much to fall out of the supports. I'll add pictures here and if anyone has a educated ideal how best to reinforce the hitch I would certainly be will to listen. Thanks